Vòng tròn nhôm để vẽ sâu

Nhôm NINGBO ZHONGBANG là nhà sản xuất nhôm CIRCLE. Chúng tôi cung cấp chất lượng tuyệt vời của vòng tròn đo nặng Đĩa nhôm được làm từ nguyên liệu chất lượng cao đảm bảo độ bền cao cho người sử dụng, đó là lý do tại sao đĩa do chúng tôi cung cấp có nhu cầu cao trong việc chế tạo các sản phẩm đồ dùng nấu nướng.

Đường kính: 20mm-1200mm

Hợp kim: 1050. 1060, 1100, 1070, 1200 3003 3103 3105 4006 vv

Nhiệt độ: mềm, 1/4 cứng, 1/2 cứng, cứng, H12, H14

suitable for deep drawing and spinning

Automatic circle blanking production line processing

The main components of the aluminum disk uncoiling and blanking production line are: loading trolley, uncoiling machine, leveling machine, feeder, swing unit, special closed single-point mechanical press, quick die changing device, palletizing unit, scrap shear Cutting, hydraulic system, electrical control system, etc.

Technical characteristics of production line:

1. Fully numerically controlled, the production line should start from the unwinding of the coil, until the entire roll of material is blanked, no manual contact with any materials is needed, no adjustments are needed, and the potential safety hazards of ordinary punches are basically eliminated Hidden product quality.

2. The line can directly use the coil to produce circles without the need for slitting and cross-cutting of the coil, which reduces the production process, reduces the cost of production, and reduces the possibility of damaging the surface of the coil. The disc is guaranteed to be free of oil and scratches.

3. This line makes full use of the width of the coil and uses high-precision servo motor drive system control to minimize the circle spacing and the distance from the circle to the material edge, radically reduce the amount of waste, and make the raw material utilization rate reach 80% the above.

4. Production speed can reach 40-55 tablets per minute, which improves production efficiency.

5. Do sử dụng thiết kế khuôn mô-đun nên khi chuyển đổi quy cách sản xuất vòng tròn, thời gian chuyển đổi có thể giảm xuống dưới 15 phút. Đường kính của các vòng tròn có thể được sản xuất nằm trong khoảng từ 85 mm đến 750 mm.

6. Hệ thống tháo cuộn tiên tiến, máy san phẳng sáu cấp, máy ép cơ học có độ cứng cao, hệ thống xếp hàng tự động, v.v., đảm bảo chất lượng cao của các sản phẩm vòng tròn.